Report inadequate content

How to use iphone or ipad touch with ELM327

{
}

Because of the limitations in the IOS Bluetooth stack, please carefully check what you buy is equipped with WIFI version rather than the Bluetooth one, unless you have jailbroken your phone and know what you are doing.
WIFI ELM327 can be ordered from Eobd2.fr, only need to pay €11.00 (free shipping). Here list detailed steps on how to use an iphone or ipad touch with ELM327 OBD tool below:
1.Communicate the ELM327 with your car.
2.In the settings on your IOS device, select to connect to a WIFI network. It is rather relatively to find out which one you should be done. For example, my ELM327 is called “CLKDevices”, but yours may be different.
3.Once connected to the WIFI network, then you can set the IP address. Configure the IP address to 192.168.0.123 and the subnet mark to 255.255.255.0 (NOTE: Do not set your IP as router).
4.Start your car, the OBD II port is offering power to the ELM327 (but in some cases you will not be able to retrieve any data from it if the is not started).
5.In the APP, configure the connection to use a custom TCP connection with IP 192.168.0.10 and TCP Port 35000.
6.Enjoy reading all this information on your car better and cheaper than by using the crappy scanners they sell in stores.

{
}
{
}

Leave your comment How to use iphone or ipad touch with ELM327

Log in to Obolog, or create your free blog if you are not registered yet.

User avatar Your name